616mm 208v 1500w Halogen Heat Lamp with R7S Base

May 9, 2026

Introduction

We built this 616mm, 208V, 1500W halogen heat lamp for one reason: to give you a compact heater that hits hard—fast. It’s all about focused infrared heat, right where you need it, when you need it. And it’s meant to be direct-wired. The R7S base means you wire it straight in—no extra sockets to fuss with. Just a clean, simple setup that stays tidy.

Technical Deep-Dive

Here’s the part that makes planning easier: it runs on 208V at 1500W. That’s power that lines up with what many plants already have, so you don’t have to chase voltage upgrades just to make it fit. Then there’s the length—616mm. That gives you a long, even radiating zone, so you can cover a wider part or a longer line without stacking a bunch of smaller lamps. Fewer lamps can mean fewer hot spots. And honestly, it makes your layout feel less complicated.

Material & Design

The halogen element sits inside a quartz envelope. That matters because quartz can handle high filament temps and won’t freak out when things heat up and cool down. The halogen cycle helps keep the element cleaner during operation, so output stays steady over time. And the R7S base? It’s a bi-pin design that clicks in and stays put, carrying the full current. The connection feels solid—electrically and mechanically—so you’re not crossing your fingers every time it fires up.

Application & Benefits

Use this lamp when you need heat that shows up fast and stays under control—think heating plastic, drying coatings, or curing a specific spot. It packs a lot of heat into a small footprint, which is great when space is tight. But that also means the surrounding area gets hot. So plan for proper shielding and cooling. Protect the lamp, and protect the components nearby—give them space to breathe, and the whole system stays tougher, longer.